Remoterig Antenna Switch 1269 remote controlled 10 way
Ref: AntennaSwitch1269
Made to orderHigh performance remote controlled 10 way antenna switch.
| The switch is designed specially to be used for remote (over the Internet) controlled systems, but can of course be used in other applications also. The switch can be manually controlled via an internal web interface. Together with Remoterig RRC-1258 it can be setup to automatically follow your band changes. The switch connects to the RRC over IP, no serial port is needed. Normally it is powered with 48V via the Ethernet cable according to the PoE standard. This means that the switch can be placed in a tower 100m from the schack. The switch is built in stainless steel and can be placed outdoors. It can be ordered with N-connectors or SO-239 both with PTFE dielectric. Specifications Frequency Range:…………………………1.6-55 MHz |
| (*1) All unused antenna outputs are grounded, The RF card control lines are surge protected with Metal Oxide Varistors (*2) The control cable should be shielded (FTP) CAT-5e or better. Users manual can be downloaded from the Users manaul page |
There is a lower cost version available also which has no built in remote control. You select the antenna by grounding the input (screew terminal). The RF data is exactly the same as for the remote switch only the control is different. | |
A PoE Power supply is available in the webshop Vin =100-240VAC Vout = 48VDC/0.6A |
Below you can see some examples of the measured data done by Mike SJ2W who developed the RF-board. The measurements are done with Rohde & Schwarz ZVR-series Vector Network Analyzer
Data sheet
- Guy
- Commutatori d'antenna
- Compatible brand
- Generico
- Sub-Categories
- Commutatori d'antenna
Specific References
- ean13
- 0644730928069