mAT-M200

mAT-M200 is specially designed for ICOM and KENWOOD brand transmitters with RF power no more than 200W (SSB). This tuner is also a great choice for users who like to operate the transmitter in digital modes such as FT8, CW and RTTY. Most tuners cannot handle 100 watts of digital mode RF signals entering the tuner. mAT-M200 allows up to 100 watts of digital mode RF signals to pass through the tuner. mAT-M200 has a working frequency range of 1.8-54MHz and a maximum allowable RF power of 200 watts. As an external antenna tuner, it is connected to the ICOM transmitter via the mAT-CI control cable or to the KENWOOD transmitter via the mAT-CK cable. The tuner comes with the mAT-CI cable by default. The transmitter supplies power to the tuner via this cable, communicates with it, and controls the operation of the tuner. The tuner does not require additional power. The tuner is compatible with ICOM and KENWOOD tuners, and users can easily control the tuner using the [TUNE] or [AT] buttons on the radio equipment panel. This makes operating the tuner very convenient.

For ICOM devices, the tuner will only work with transmitters with a standard 4-pin ICOM tuner socket. If your transmitter does not have this socket, you will not be able to use it. If your transmitter has a non-standard 4-pin ICOM tuner socket, such as IC-M710, M802, IC-F7000, IC-F8101, you will need to modify the mAT-CI cable so that it can connect to the TUNER of these transmitters before you can use this tuner. The same goes for KENWOOD devices, but their TUNER socket is 6-pin. When the tuner is turned on and started, it will detect whether it is currently connected to an ICOM device or a KENWOOD device and will automatically pair with it.

It will match dipoles, verticals, Yagis, or virtually any coax-fed antenna. It will match an astonishing range of antennas and impedances, much wider than some other tuners you may have considered, including the tuners built into many radios.