ACOM 2S1 XCVR automatic transfer switch

PRODUCT DELIVERED WITHIN 7/15 DAYS DEPENDING ON AVAILABILITY

The ACOM2S1 is a TX/RX switch that allows a two transceivers use a common load. It guards the entrance each transceiver while the other transceiver transmits, prevents simultaneous transmission, and allows simultaneous reception.

The ACOM2S1 was specially designed for complete the ACOM2000S automatic antenna / SW selector (plus switch remote antenna ACOM2000SW) and the automatic ACOM2000A linear HF amplifier.

However, it can not only be used for switching an antenna, but can also be adapted into other systems. The operation it is fully automatic and full break-in mode (QSK) is standard.

PARAMETERS

- Frequency coverage : All amateur bands 1.8-54MHz.

- Power through line : up to 200W PEP or continuous carrier.

- Input and Output Impedances : - 50 Ohm nominal, unbalanced, UHF (SO239) connector type. - VSWR below 1.1: 1 (1.8-54MHz); below 1.2:1 up to 80MHz.

- Power supply : 11-14 VDC, less consumption of 30mA.

- Dimensions and weight (operating) : W110mm x D42mm x H67mm, 350g, incl. cables (4-1/3"W x 1-2/3"D x 2-2/3"H, 0.8kg).

- Operating temperature: 0 ... +50°. Centigrade.

FUNCTIONS :

- System T/R: QSK mode capable.

- Protections: an input transceiver is a ground while the other transceiver is transmitting;

- Simultaneous transmission is prevented;

- T/R sequencing and RF relay contacts are continuously monitored.

STORAGE AND SHIPPING:

- Storage environments: the collector can be kept packaged in unheated, dry and ventilated rooms, without substances chemically active (acids, alkalis, etc.) in the following climatic environment;

- temperature range: from -40 to +70 degrees centigrade;

- Humidity: up to 75% @ +35 degrees centigrade;

- Shipping Size and Weight: W200mm x D150mm x H70mm, 450g (8"W x 6"D x 2-3/4"H, 1kg)