mAT-K100 Automatic antenna tuner dedicated to Kenwood and Icom equipment

The mAT-K100 provides automatic antenna tuning across the entire HF spectrum plus 6 meters, at power levels up to 120 watts. It will tune dipoles, verticals, yagis or pretty much any coax-fed antenna. It will match an extraordinary range of antennas and impedances, far superior to that of other tuners you may have considered, including the built-in tuners on many radios.

The mAT-K100 is an automatic antenna tuner specially designed for i modern ICOM and KENWOOD HF transceivers. It has two control cables to choose from: mAT-CI and mAT-CK. They are suitable for ICOM and KENWOOD transceivers respectively. With the corresponding control cables, the tuners can be used for the corresponding transceivers.

The standard cable included in the mAT-K100 is only the KENWOOD mAT-CK control cable, if you need mAT-CI, please buy more.

When mAT-K100 is used in ICOM transceiver via control cable mAT-CI, is fully compatible with AH-3 and AH-4 automatic tuners originals from ICOM. Transceivers that can use both tuners ICOM can also use mAT-K100, which includes the series transceivers IC-706, 703, 718, 7000, 7100, 7200, 7300, 7410, 746, 756, 7600 . When the tuner is used in the KENWOOD transceiver via the cable mAT-CK control, is fully compatible with original KENWOOD tuners, such as AT-250, AT-300. KENWOOD transceivers that can use mAT-K100 they are TRC-80, TK-80, TS-2000, 50, 450, 480SAT (excluding HX version), 570, 590, 850, 870, 990, etc.

Can other types of mAT-K100 transceivers can be used as long as they support KENWOOD AT-300 tuners. KENWOOD TS-430, TS-440 are too old to use this tuner. The mAT-K100 has 16,000 frequency memories. When tunes to or near a previously tuned frequency, the mAT-K100 uses "Memory Tune" to recall previous tuning parameters in a fraction of a second.

Self there are no stored settings, the tuner cycles complete tuning, storing the parameters for memory recall in subsequent tuning cycles on that frequency. In this way, the mAT-K100 "learns" as it is used, adapting to bands and frequencies as it proceeds. 20150508_135054 As shown above, the front panel of the mAT-K100 it's very simple. There are two indicator lights on the front panel, which come used to display the online/bypass status of the tuner respectively and the power supply. 20150508_135054 There are two types of control cables for mAT-K100: KENWOOD and ICOM. The control cable provides the control signals between the transceivers and the tuner and the power supply for the tuner. When the tuner starts up, it can automatically identify whether the transceiver KENWOOD is currently connected or ICOM and works with the corresponding software without any setting by the operator.